LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Structure >> Rear Bumper >> Parts Location >> Removal

Parts Location: Removal

  1. Disconnect the battery ground cable.
  2. Remove the rear bumper fascia.
    • Remove the two screws (1), six bolts (3) and nine clips (2).
      Fig 1: Identifying Clip & Bolts Of Rear Bumper Fascia
      G02809048Courtesy of ISUZU MOTOR CO.
  3. Remove the rear bumper retainer assembly.
    • Remove the four nuts.
  4. Remove the rear bumper retainer bracket assembly.
    • Remove the two nuts (1) from both sides.
      Fig 2: Identifying Nuts Of Rear Bumper Retainer Bracket Assembly
      G02809049Courtesy of ISUZU MOTOR CO.
  5. Remove the rear bumper reinforcement assembly.
    • Remove the six bolts.
      Fig 3: Identifying Bolts Of Rear Bumper Reinforcement Assembly
      G02809050Courtesy of ISUZU MOTOR CO.
  6. Remove the rear bumper support assembly (5).
    • Remove the two nuts (4) and the screw (6) from both sides.
  7. Remove the rear bumper side bracket (3).
    • Remove the two nuts (4) from both sides.
  8. Remove the rear bumper mounting (2).
    • Remove the screw (1) from each sides.
      Fig 4: Identifying Screw Of Rear Bumper Mounting
      G02809051Courtesy of ISUZU MOTOR CO.
  9. Remove the rear bumper back bar assembly.
    • Remove the two bolts from both sides.
      Fig 5: Identifying Bolts Of Rear Bumper Back Bar Assembly
      G02809052Courtesy of ISUZU MOTOR CO.
  10. Remove the reflector assembly.
    • Remove the two nuts.
scientia non olet · About LEMON Manuals