Rear Wiper/Washer

REAR WIPER AND WASHER SWITCH

REMOVAL

1. Disconnect the battery ground cable.
2. Remove the dash side trim panel (1).




3. Remove the lower cover assembly (2).
- Refer to Instrument Panel Assembly in Body Structure.

4. Remove the meter cluster assembly (4).




5. Remove the rear wiper & washer switch (5).
- Disconnect the connector.
- Push the lock from the back side of the meter cluster assembly.

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following point:
1. Push the switch with your fingers until it locks securely.