B-24

Chart B-24 Wheel Speed Input Abnormality (DTC 65 (Flash out) / C0238 (Serial communications))





Sensor Signal Abnormality Criteria using TECH 2
1. While driving, the speed of one or two wheels is 25% or more higher or lower than that of the other wheels.
2. The speed of one or two wheels is 10 km/h (6 mph) or more higher or lower than that of the other wheels.
3. During steady driving, wheel speed changes abruptly.
*1 The vehicle must run on a level paved road.

Note: Even after repairing the faulty part the Warning Light (W/L) does not go out if the vehicle is at a stop.
Turn the ignition switch to the ON position and drive the vehicle at 12 km/h (8 mph) or higher to make sure that the warning light goes out.
It is important to verify that the correct tires are installed on vehicle.