LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1998 >> Trooper S, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> ZEXEL Rotary Vane >> Clutch Coil & Bearing >> Installation

Clutch Coil & Bearing: Installation

  1. To install, reverse removal procedure. Align clutch coil pin with hole in front head of compressor and install clutch coil. Tighten clutch coil screws to 44 INCH lbs. (5 N.m). Using pulley installer and drive handle, tap pulley onto compressor. Install new snap ring.
  2. On DKV-14D compressor, tighten clutch plate bolt to 113 INCH lbs. (13 N.m) Using feeler gauge, ensure air gap between clutch plate and pulley is 0.012-0.024" (0.30-0.60 mm). If air gap is incorrect, add or remove shim(s) as necessary.
Fig 1: Exploded View Of Compressor (Zexel DKV-14D Rotary Vane)
G95A10025Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals