LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1998 >> Trooper S, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Power Seats >> Removal & Installation >> Seat Motors >> Removal & Installation (Recliner Motor)

Removal & Installation (Recliner Motor)

  1. Turn ignition switch to OFF position. Remove appropriate seat. See SEAT ASSEMBLY  . Remove seat back. Remove lower recliner retaining bolt, and separate seat back and seat cushion.
  2. Disconnect heater harness connector (if equipped). Remove trim cover hog rings from seat back assembly. Move trim cover aside and remove upper recliner retaining bolt. Disconnect recliner connecting shaft and harness connectors. Remove recliner motor. See Figure . To install, reverse removal procedure.
scientia non olet · About LEMON Manuals