LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1998 >> Trooper S, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Trouble Shooting >> Front Washer Motor Inoperative >> Hombre

Front Washer Motor Inoperative: Hombre

  1. Disconnect washer pump connector. Connect a test light between washer pump terminals "A" (Red wire) and "B" (Black wire). See WIRING DIAGRAMS . Turn ignition switch to ON position. Activate washer pump with wiper/washer switch. If test light comes on, go to next step. If test light does not come on, go to step 3).
  2. Check for poor connections to washer pump. If connections are okay, replace washer pump. See FRONT WASHER MOTOR  under REMOVAL & INSTALLATION.
  3. Connect test light between ground and washer pump connector terminal "A" (Red wire). See WIRING DIAGRAMS . Activate washer pump with wiper/washer switch. If test light comes on, go to next step. If test light does not come on, go to step 5).
  4. Repair open Black wire between washer motor and ground. See WIRING DIAGRAMS .
  5. With test light connected to ground, backprobe terminal E9 (Red wire) of wiper/washer switch connector. See WIRING DIAGRAMS . Activate washer pump with wiper/washer switch. If test light comes on, go to next step. If test light does not come on, go to step 7).
  6. Repair open Red wire between washer motor and wiper/washer switch. See WIRING DIAGRAMS .
  7. Check for poor connection at wiper/washer switch connector terminal E9 (Red wire). See WIRING DIAGRAMS . If connections are okay, replace wiper/washer switch. See MULTIFUNCTION SWITCH  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals