LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1998 >> Trooper S, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Power Seats >> Trouble Shooting >> Driver's Seat Rear Tilt Inoperative

Driver's Seat Rear Tilt Inoperative

  1. Disconnect driver's power seat switch connector T-1. With driver's power seat switch in neutral position, use DVOM to check for continuity between switch terminals No. 2 and 9, and between terminals No. 4 and 7 (switch side). If continuity is indicated, go to next step. If continuity is not indicated, at all terminals, replace switch. See POWER SEAT SWITCHES  under REMOVAL & INSTALLATION.
  2. Disconnect driver's seat rear tilt motor connector T-6. Momentarily connect fused jumper wire between battery voltage and driver's seat rear tilt motor connector (motor side) terminal No. 1 (Red wire). Connect jumper wire between ground and driver's seat rear tilt motor connector (motor side) terminal No. 2 (Black wire). Reverse connections. If seat rear tilt motor operates in both directions, go to next step. If motor does not operate in both directions, replace driver's seat rear tilt motor. See SEAT MOTORS  under REMOVAL & INSTALLATION.
  3. Repair open in Blue wire or Blue/Red wire between driver's power seat switch and rear tilt motor. See WIRING DIAGRAMS  . After repairs, recheck system operation.
scientia non olet · About LEMON Manuals