LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1997 >> Oasis LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Brake Shoes >> Removal

Rear Brake Shoes: Removal

  1. Raise and support rear of vehicle. Remove rear wheels and brake drums. Remove upper return spring. Detach shoe tension pins by pushing in on retaining spring and turning tension pin 90 degrees to align with spring slot.
  2. Lower brake shoe assembly to clear wheel cylinder, and remove lower return spring. Note original position of all springs. See Fig 1 .
    CAUTION: Ensure wheel cylinder rubber dust covers are not damaged during brake shoe removal.
  3. Remove brake shoe assembly. Disconnect parking brake cable from parking brake lever assembly. Separate brake shoes. Remove self-adjuster bolt, lever and spring. Pry off circlip, and remove washer, pivot pin and parking brake lever (if necessary). Mark parking brake lever for left or right position.
Fig 1: Exploded View Of Rear Drum Brake Assembly (Typical)
G90G05939Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals