LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1996 >> Rodeo LS, 3.2 V, 4WD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Automatic Locking Hub Without Shift-On-The-Fly System >> Removal

Automatic Locking Hub Without Shift-On-The-Fly System: Removal

  1. Place transfer case lever in 2H position. Move vehicle back and forth about 3 feet or more. Raise and support vehicle. Remove wheel and brake caliper. Wire caliper aside. Remove 6 bolts and locking hub cover and housing. See Fig 1 .
    Fig 1: Exploded View Of Automatic Locking Hub Without Shift-On-The-Fly System
    G92G00477Courtesy of ISUZU MOTOR CO.
  2. Remove snap ring and shims. Remove clutch assembly with inner cam. Remove lock washer. Using Hub Nut Wrench (J-36827), remove hub nut. Remove outer bearing with hub and rotor assembly. Mark hub and rotor relation if they are to be separated.
scientia non olet · About LEMON Manuals