Transfer Rear Case Assembly (4WD): Reassembly

1. Press on front ball bearing using Ball Bearing Installer (J37223) and Adapter (J37486). Install front bearing rear snap rings, speedometer drive gear with clip and rear bearing front snap ring. Press on rear ball bearing using ball bearing installer. Install rear bearing rear snap ring. Install rear oil seal using Oil Seal Installer (J29769) and a hammer.
2. Wrap splines of rear output shaft with vinyl tape and install into transfer rear case. Install front bearing front snap ring using snap ring pliers. Remove vinyl tape.

Fig 1: Exploded View Of Transfer Rear Case Assembly

Courtesy of ISUZU MOTOR CO.