LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1994 >> Trooper S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Servicing - M/T) >> Adjustments >> Gearshift Cables >> Impulse & Stylus

Impulse & Stylus

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1992 Isuzu Trooper, 1992 Isuzu Stylus, 1992 Isuzu Rodeo, 1992 Isuzu Pickup, and 1992 Isuzu Impulse. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place transaxle in Neutral. Rotate gearshift cable adjusting nuts until gearshift is at right angle to case when viewed from side. See Fig 1 . Gearshift should be in a vertical position and not slanted.
  2. If gearshift is not as specified above, rotate select cable adjusting nuts until shift lever is at right angle to case when viewed from rear of case. After shift lever is properly positioned, tighten all adjusting nuts to 17 ft. lbs. (23 N.m).
    Fig 1: Adjusting Gearshift Cables (Impulse & Stylus)
    G91C00507Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals