LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1994 >> Trooper S, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.2L V6 - VINS [V,W] >> Removal & Installation >> Cylinder Head Covers >> Removal & Installation (SOHC Right Side)

Removal & Installation (SOHC Right Side)

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION. Disconnect negative battery cable. Remove plug wires at spark plugs.
  2. Remove upper intake manifold. See UPPER INTAKE MANIFOLD  under REMOVAL & INSTALLATION. Remove vent hose from cylinder head cover. Remove fuel hose assembly retaining bolts. Disconnect fuel feed and return hoses.
  3. Remove right side exhaust manifold heat shield. Remove engine hanger from cylinder head and exhaust manifold. Remove heater pipe from bracket. Remove bolts and cylinder head cover.
  4. To install, clean sealing surfaces. Apply RTV sealant to corners of end camshaft towers and install NEW gasket. See Figure. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals