LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1994 >> Trooper S, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.2L V6 - VINS [V,W] >> Overhaul >> Cylinder Head >> Valve Guides

Valve Guides

  1. Check valve stem-to-guide oil clearance. Ensure valve stem diameter is within specification. Replace valve guide if clearance exceeds specification. Manufacturer recommends replacing valve and valve guide as a set. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS.
  2. To replace valve guide, use hammer and Valve Guide Remover/Installer (J-37985). Working from combustion side of cylinder head, drive valve guide out of top of head. Apply engine oil to outside of NEW valve guide.
  3. Using hammer and valve guide remover/installer, drive valve guide into cylinder head from camshaft side. Measure valve guide installed height from top of valve guide to cylinder head surface. Ensure valve guide installed height is within specification. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS. Using reamer, ream valve guide to obtain specified valve stem-to-guide oil clearance. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals