LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1993 >> Stylus Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Disc Brake Pads >> Removal (1.8L)

Removal (1.8L)

  1. Raise and support vehicle. Remove rear wheels. Release parking brake fully. Disconnect parking brake cable from caliper. Remove lock bolt.
  2. Rotate caliper upward and remove caliper from support bracket. Mark pad locations if reusing. Remove pads and shims. Remove and discard pad clips. To depress piston, install Piston Adapter (J-37617) to uneven section of piston.
  3. Open bleed screw. Rotate piston adapter clockwise until piston stops turning. Back piston out slightly until piston is centered. See Figure . Minimum pad lining thickness is .04" (1.0 mm).
scientia non olet · About LEMON Manuals