LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1993 >> Stylus Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Bleeding Brake System >> Bleeding Procedures >> Pressure Tank Bleeding

Pressure Tank Bleeding

  1. Start engine and run at idle. Clean master cylinder cap and surrounding area, then remove cap. With pressure tank at least 1/2 full, connect tank to master cylinder using proper adapter(s).
  2. Attach bleed hose to first wheel cylinder bleed screw to be serviced. See BRAKE LINE BLEEDING SEQUENCE table. Place other end of hose in clean transparent container. Partially fill container with clean brake fluid until end of hose is submerged in fluid.
  3. Open release valve on pressure tank. Open bleed screw, noting fluid flow. When fluid flowing into container is clear and bubble free, close bleed screw securely.
  4. Finish bleeding system in the same manner using correct sequence. Close release valve, and remove pressure tank from master cylinder. Check fluid level of master cylinder reservoir.
BRAKE LINE BLEEDING SEQUENCE

Application Sequence
Stylus LF, RR, RF, LR
scientia non olet · About LEMON Manuals