Brake Pedal Height, Free Play & Stoplight Switch

NOTE: Push rod serves as brake pedal stopper when brake pedal is fully released. Pedal free play is measured with engine off and brake pedal depressed 5 times to release power brake unit power assist.

With brake pedal fully returned, measure pedal height from upper foot rest portion of pedal pad to floor board. Pedal height should be 6.2" (157 mm).
To adjust pedal height, disconnect battery negative cable. Unplug stoplight switch connector. Loosen stoplight switch to ensure brake pedal is fully returned. Loosen push rod lock nut. Rotate push rod to obtain specified pedal height. Tighten push rod lock nut.
Rotate stoplight switch so switch rests against rubber stopper on pedal arm. Carefully rotate stoplight switch until switch housing lightly contacts pedal stopper. Reconnect stoplight switch connector and battery negative cable.