LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1992 >> Impulse XS, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [4,5,6] & 1.8L 4-CYL - VIN [8] >> Removal & Installation >> Cylinder Head >> Installation (All Engines)

Installation (All Engines)

  1. To install, reverse removal procedure. Tighten cylinder head bolts in sequence. See Figure or Figure . Tighten bolts in 2 steps to specification. See TORQUE SPECIFICATIONS  .
  2. If cylinder head components were serviced, valve clearance should be checked. See VALVE CLEARANCE ADJUSTMENT  under ADJUSTMENTS.
  3. Before installing valve cover, apply Sealant (TB-1207B) at valve cover-to-camshaft bearing cap surfaces for No. 1 and No. 5 bearing caps. To install valve cover, reverse removal procedure.
  4. Tighten valve cover bolts in proper sequence. See Figure . Tighten bolts to specification. See TORQUE SPECIFICATIONS  . Ensure fluid levels are within specification.
scientia non olet · About LEMON Manuals