LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1992 >> Impulse XS, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [4,5,6] & 1.8L 4-CYL - VIN [8] >> Removal & Installation >> Camshaft >> Installation (SOHC)

Installation (SOHC)

  1. Lubricate camshaft with engine oil. Install camshaft in cylinder head. Ensure locating dowel for camshaft sprocket is at the 12 o'clock position. Apply Sealant (TB-1207B) to contact surfaces between camshaft bearing caps and cylinder head for No. 1 and No. 5 bearing caps. See Figure .
  2. Install camshaft bearing caps in original location. Tighten bolts in sequence to specification. See Figure . See TORQUE SPECIFICATIONS  .
  3. Lubricate seal lip with engine oil. Using Seal Installer (J-35268), install new seal on camshaft.
  4. To install remaining components, reverse removal procedure. Ensure reference marks align when installing distributor, and timing marks align when installing timing belt.
    CAUTION: If cylinder head or camshaft are serviced or replaced, valve clearance must be checked. See VALVE CLEARANCE ADJUSTMENT  under ADJUSTMENTS.
  5. Before installing valve cover, apply Sealant (TB-1207B) at valve cover-to-camshaft bearing cap surfaces for No. 1 and No. 5 bearing caps. To install valve cover, reverse removal procedure.
scientia non olet · About LEMON Manuals