LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1988 >> Trooper II Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.3L 4-CYL - VIN [L] & 2.6L 4-CYL - VIN [E] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Clean gasket surfaces. Clean head bolts and threads in cylinder block. Install new head gasket with side marked "TOP" facing upward. Apply a thin coat of engine oil to head bolt threads. Install cylinder head, but DO NOT  tighten bolts.
  2. Apply a thin coat of oil to front cover bolts and install. Tighten cylinder head bolts and front cover bolts to specifications. Tighten cylinder head bolts in 2 steps and in sequence. See Fig 1. Tighten bolts to 58 ft. lbs. (78 N.m) on first step and then to 73 ft. lbs. (99 N.m) on second step. Reverse removal procedure to complete installation.
Fig 1: 2.3L & 2.6L Cylinder Head Tightening Sequence
G99086Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals