LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1985 >> Impulse 2.0 F, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [B], 1.9L 4-CYL [A], 2.0L 4-CYL [F] >> Removal & Installation >> Intake Manifold >> Removal (I-Mark, P'UP & Trooper II)

Removal (I-Mark, P'UP & Trooper II)

  1. Completely drain cooling system. Remove air cleaner assembly. Disconnect radiator, fuel and vacuum hose from intake manifold. Disconnect heater hoses at firewall and from rear of intake manifold. Disconnect accelerator cable from carburetor.
  2. Disconnect distributor vacuum hose, temperature sending unit and temperature switch wiring. Disconnect choke and solenoid wiring from carburetor. Disconnect ground wire and canister purge hose.
  3. Disconnect EFE heater wiring and PCV hose from valve cover. Disconnect EGR pipe from EGR valve. Disconnect air injection vacuum hose from 3-way connector. Remove intake manifold and carburetor assembly.
scientia non olet · About LEMON Manuals