LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1985 >> Impulse 2.0 F, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [B], 1.9L 4-CYL [A], 2.0L 4-CYL [F] >> Overhaul >> Connecting Rod Bearings

Connecting Rod Bearings

Mark connecting rod and cap (on starter side of engine) for cylinder identification and remove rod cap. Check bearing clearance using Plastigage. If clearance is excessive, install new bearing. Replacement bearings are available in standard, .010" (.25 mm) undersize and .020" (.50 mm) undersize.

scientia non olet · About LEMON Manuals