LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1984 >> Impulse Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [B] & 1.95L 4-CYL - VIN [A] >> Removal & Installation >> Camshaft >> Removal

Removal & Installation: Camshaft: Removal

  1. Remove valve cover. Remove mechanical fuel pump, if used. Rotate camshaft until No. 4 piston is in firing position. Remove distributor cap and mark rotor position on housing.
  2. Lock timing chain tensioner by depressing and turning slide pin 90° clockwise. See Figure . Check chain for slack after locking tensioner.
  3. Remove fuel pump drive cam (if used) and camshaft sprocket with timing chain attached. DO NOT  separate chain and sprocket. Remove rocker arm shaft and bracket assembly. Remove camshaft.
scientia non olet · About LEMON Manuals