Engine Identification: Engine: Removal
- Disconnect battery cables. Remove lower engine cover. Drain crankcase and cooling system. Remove air cleaner assembly. Disconnect accelerator cable and necessary linkages from carburetor. Scribe hinge position on hood and remove hood.
- Disconnect all coolant and fuel hoses attached to engine. Disconnect and label for reassembly all necessary vacuum lines, electrical, and ignition wiring attached to engine. Disconnect exhaust pipe at manifold. Remove radiator and cooling fan.
- Disconnect drive shaft, slave cylinder (or clutch cable) and speedometer cable from transmission. If equipped with A/C or power steering, remove from engine and position aside. DO NOT disconnect refrigerant lines.
- Remove starter. Remove flywheel inspection cover and bell housing bolts. If equipped with automatic transmission, remove drive plate to torque converter bolts.
- Support transmission. Attach hoist and lifting chain to engine. Remove front and rear engine mount nuts.
- Ensure all necessary wiring, hoses, lines, and linkages have been disconnected from engine. Separate engine from transmission and lift out of engine compartment.