LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1983 >> Impulse Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [B],1.9L [A], 1.95L 4-CYL - VIN [A] >> Engine Identification >> Crankshaft End Thrust

Crankshaft End Thrust

  1. To check crankshaft end thrust, install bearings in cylinder block, then lay crankshaft in place. Install thrust bearing on both sides of No. 3 crankshaft journal.
  2. Move crankshaft fully endwise and measure clearance between crankshaft thrust face and thrust bearing. If clearance is greater than .012" (.30 mm), replace thrust bearings.
scientia non olet · About LEMON Manuals