Manual Steering Gears - (GEMMER/ROSS) Cam & Lever: Overhaul: Inspection

Use cleaning solvent to clean parts and dry parts with compressed air taking care not to spin bearings. Inspect cam groove for chipping, scoring or binelling and condition of splies and threads. Check all bearings and bearing surfaces on all parts for wear. Check lever shaft for burrs on splines, twisted splines and wear on bearing surfaces. Check cam follower(s) for nicks, flat spots or spoiling. Inspect cam follower roller bearings for wear. Check housing for strain at mounting flanges, bushings for wear or out-of-round and oil seals for nicks.