LEMON Manuals: Even more car manuals for everyone
Home >> International >> 1971 >> M800 5.0L Eng, _NA_ >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Windshield Wipers - 2-Speed Electric >> Overhaul >> Plate Actuated Motor >> Reassembly

Plate Actuated Motor: Reassembly

  1. If field coils were removed, solder coil lead to insulated brush holder. Place 10 drops of engine oil to felts at armature shaft bushings and allow excess to drain off. Use suitable grease on crankarm shaft and insert one tablespoon of Lubri-Plate Aero Lubricant or equivalent in gear case. Position armature in motor housing and slide drive end housing over armature worm gear. Position brush springs and brushes in holders and hold brushes in place while inserting armature into commutator end frame bushing.
    NOTE: Check that leads do not interfere with armature or brush movement.
  2. Install commutator end frame on housing, place drive end housing in position on motor housing and install through bolts. Tighten bolts and strike motor once or twice to align bushings. Install thrust washer and spring washer on crankarm shaft. Grease shaft and install in commutator end frame bushing. Position drive gear thrust washer, gear key and crankarm drive gear on shaft.
  3. Install switch contact plate in position noted at disassembly. Install insulating washer, flat washer, lock washer and nut on crankarm shaft. Tighten nut. Install drive end cover on housing.
scientia non olet · About LEMON Manuals