DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms(Trouble diagnosis content)	DTC detection condition
P2813	SELECT SOLENOID(Select solenoid)	1	Diagnosis condition	When all of the following conditions are satisfied: DTC other than the applicable DTC is not detected. Throttle position: More than 6.27 deg. Vehicle speed: Less than 3 km/h (1 MPH) CVT fluid temperature: More than 20°C (68°F) Shift position: Other than P, N Turbine speed when performed N → D, N (P) → R: More than 500 rpm TCM power supply voltage: More than 11 V
			Signal	-
			Threshold	When all the following conditions are established three times in 1DC: Input speed: 200 rpm or less. Detection time after select position N → D: Less than 0.4 seconds N → R: Less than 0.3 seconds P → R: Less than 0.3 seconds
			Diagnosis delay time	-
		2	Diagnosis condition	When all of the following conditions are satisfied: Shift position: Other than P, N Vehicle speed: Less than 3 km/h (1 MPH) Differences between primary pulley speed and secondary speed: Less than 120 rpm DTC other than the applicable DTC is not detected. TCM power supply voltage: More than 11 V
			Signal	-
			Threshold	When all of the following conditions are satisfied: Clutch instructions pressure: 0.95 MPa or more Differences between turbine speed and input speed: Less than 200 rpm Turbine speed - speed: More than 450 rpm
			Diagnosis delay time	The counting of time continues while diagnosis conditions are satisfied and stops when the conditions become unsatisfied (the count is maintained). When accumulated time reaches 30 seconds (Clutch is judged as engaged and the count is reset.)

DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF → ON → driving → OFF".

POSSIBLE CAUSE

Select solenoid valve

FAIL-SAFE

When a malfunction occurs on the low oil pressure side
- Selector shock is large
- Start is slow
- Acceleration is slow
- Vehicle speed is not increased
When a malfunction occurs on the high oil pressure side
- Selector shock is large