DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms(Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| P272B | 00 | T/M range select motor(Transmission Range Select Motor Control Circuit Current Too High) | Diagnosis condition | When Ignition switch is ON |
| Signal | Motor A (U phase / V phase / W phase) signal | |||
| Threshold | Either of two energized phases is in the non-energized state.
NOTE:
|
|||
| Diagnosis delay time | - | |||
POSSIBLE CAUSE
- Harness or connectors
- Motor coil A (U phase / V phase / W phase) circuit is shorted to power.
- Motor coil B (U phase / V phase / W phase) circuit is shorted to power.
- Electric shift control module
FAIL-SAFE
Shifting operation is prohibited