DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms(Trouble diagnosis content)	DTC detection condition
P0841	FLUID PRESS SEN/SW A(Transmission Fluid Pressure Sensor/Switch "A" Circuit Range/Performance)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected. Primary pulley speed: 300 rpm or more Secondary pulley speed: 250 rpm or more Target speed for shifting: Less than 0.1 seconds Pulley ratio: 0.5 - 1.0
		Signal	-
		Threshold	Primary pulley pressure is outside the specified value
		Diagnosis delay time	Maintained for 5 seconds

POSSIBLE CAUSE

Harness or connector (Secondary pressure sensor circuit is open or shorted)
Harness or connector (Primary pressure sensor circuit is open or shorted)
Secondary pressure sensor

FAIL-SAFE

Not changed from normal driving