DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms(Trouble diagnosis content)	DTC detection condition
P0711	FLUID TEMP SENSOR A(Transmission Fluid Temperature Sensor A Circuit Range/Performance)	1	Diagnosis condition	When all of the following conditions are satisfied. TCM power supply voltage: More than 11 V CAN communication is normal Engine speed: 450 rpm or more Accelerator pedal position: 3 deg. or more Vehicle speed: 10 km/h (7 MPH) or more U0100, P0705 and P0706 are not detected. Shift position: "D" position
			Signal	CVT fluid temperature sensor signal
			Threshold	CVT fluid temperature does not rise to 10°C (50°F) after driving for a certain period of time with the TCM-received fluid temperature sensor value between - 40°C (-40°F) and 9°C (48.2°F).
			Diagnosis delay time	-
		2	Diagnosis condition	All of the following conditions are satisfied within 2 seconds after the ignition switch is turned ON. U0073, U0100, P0712 and P0713 are not detected. CAN communication is normal. TCM power supply voltage: More than 11 V The difference between CVT fluid temperature and engine coolant temperature is 55°C (131°F) or more, or -27°C (-16°F) or less.
			Signal	CVT fluid temperature sensor signal
			Threshold	When all of the following conditions are satisfied ECM is normal. Diagnosis condition is satisfied.
			Diagnosis delay time	Maintained for 300 seconds

POSSIBLE CAUSE

CVT fluid temperature sensor

FAIL-SAFE

Engine coolant temperature when engine start: Temp. ≥ 10°C (50°F)
- Start is slow
- Acceleration is slow
Engine coolant temperature when engine start: -35°C (-31°F) ≤ Temp. < 10°C (50°F)
- Selector shock is large
- Start is slow
- Acceleration is slow
Engine coolant temperature when engine start: Temp. <-35°C (-31°F)
- Selector shock is large
- Start is slow
- Acceleration is slow