DTC Diagnosis Procedure
NOTE:
The Signal Tech II Tool [- (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS sensor IDs
- Display tire pressure reported by the TPMS sensor
- Read TPMS DTCs
- Register TPMS sensor IDs
- TIRE PRESSURE MONITORING SYSTEM CONFIGURATION
- Perform configuration. Refer to Work Procedure (Before Replacement) or Work Procedure (After Replacement) .
>>
GO TO 2.
- TIRE PRESSURE SENSOR ID REGISTRATION
- Perform tire pressure sensor ID registration. Refer to Work Procedure .
Does low tire pressure warning lamp turn OFF?
YES>>
Inspection End.
NO>>
Perform configuration of TPMS again. Refer to Work Procedure (Before Replacement) or Work Procedure (After Replacement) .