DTC Description

DTC DETECTION LOGIC

NOTE:

The Signal Tech II Tool [- (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

DTC No.	CONSULT screen terms(Trouble diagnosis content)	DTC detecting condition
C1734-00	CONTROL UNIT(Control unit)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	-
		Threshold	TPMS malfunction in BCM.
		Diagnosis delay time	-

POSSIBLE CAUSE

BCM

FAIL-SAFE

-

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Ignition switch ON.
  2. Select "Self Diagnostic Result" mode of "BCM(AIR PRESSURE MONITOR)".
  3. Check DTC.
Is DTC "C1734-00" detected?

YES>>

Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.