DTC Description

DTC DETECTION LOGIC

NOTE:

The Signal Tech II Tool [- (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

DTC No.	CONSULT screen terms(Trouble diagnosis content)	DTC detecting condition
C1716-00	[PRESSDATA ERR] FL(Pressure data error front left)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Tire pressure sensor signal (-).
		Threshold	Malfunction in the tire pressure data from the front LH wheel tire pressure sensor.
		Diagnosis delay time	-
C1717-00	[PRESSDATA ERR] FR(Pressure data error front right)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Tire pressure sensor signal (-).
		Threshold	Malfunction in the tire pressure data from the front RH wheel tire pressure sensor.
		Diagnosis delay time	-
C1718-00	[PRESSDATA ERR] RR(Pressure data error rear right)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Tire pressure sensor signal (-).
		Threshold	Malfunction in the tire pressure data from the rear RH wheel tire pressure sensor.
		Diagnosis delay time	-
C1719-00	[PRESSDATA ERR] RL(Pressure data error rear left)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Tire pressure sensor signal (-).
		Threshold	Malfunction in the tire pressure data from the rear LH wheel tire pressure sensor.
		Diagnosis delay time	-

POSSIBLE CAUSE

Excessive tire pressure
Tire pressure sensor
BCM

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Ignition switch ON.
    CAUTION:
    Never start the engine.
  2. Check tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure .
  3. Select "Self Diagnostic Result" mode of "BCM(AIR PRESSURE MONITOR)".
  4. Check DTC.
Is DTC "C1716-00", "C1717-00", "C1718-00", or "C1719-00" detected?

YES>>

Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.