LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2024 >> QX55 Essential >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System (Direct Adaptive Steering) (DTC/Circuit Diagnosis) (2 Of 2) >> DTC/Circuit Diagnosis >> C13F1-00 INCOMP St ANG Sen ADJST >> EPS/DAST 3 >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

  1. PERFORM CALIBRATION 
    1. Perform the working including "DAST CALIBRATION (MODE1)" performed just before from the first. Refer to Work Procedure .

    >>

    GO TO 2.

  2. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION 
    1. Adjust neutral position of steering angle sensor. Refer to Work Procedure .

    >>

    GO TO 3.

  3. PERFORM SELF-DIAGNOSIS 
    1. SYMBOL CONSULT
      1. Ignition switch ON.
      2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
      3. Ignition switch OFF and wait for at least 10 seconds.
      4. Ignition switch ON.
      5. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

    Is DTC "C13F1-00" detected?

    YES>>

    Replace steering force control module. Refer to Removal and Installation .

    NO>>

    Inspection End.

scientia non olet · About LEMON Manuals