DTC Diagnosis Procedure
- PERFORM CALIBRATION
- Perform the working including "DAST CALIBRATION (MODE1)" performed just before from the first. Refer to Work Procedure .
>>
GO TO 2.
- PERFORM SELF-DIAGNOSIS
CONSULT
- Ignition switch ON.
- Erase "Self Diagnostic Result" mode of "DAST 1".
- Ignition switch OFF and wait for at least 10 seconds.
- Ignition switch ON.
- Select "Self Diagnostic Result" mode of "DAST 1".
Is DTC "C13F0-00" detected?
YES>>
Replace steering angle main control module. Refer to Removal and Installation .
NO>>
Inspection End.