DTC Diagnosis Procedure
- PERFORM CONFIGURATION
- Perform configuration for control module. Refer to Work Procedure .
>>
GO TO 2.
- PERFORM SELF-DIAGNOSIS
CONSULT
- Ignition switch ON.
- Erase "Self Diagnostic Result" mode of "DAST 2".
- Ignition switch OFF and wait for at least 10 seconds.
- Start engine.CAUTION:
Never drive the vehicle.
- Select "Self Diagnostic Result" mode of "DAST 2".
Is DTC "C13EF-00" detected?
YES>>
Replace steering angle sub control module. Refer to Removal and Installation .
NO>>
Inspection End.