DTC Diagnosis Procedure

1. CONSULT
   1. Start the engine.
      CAUTION:

      Never drive the vehicle.

   2. Select "C/M TEMPERATURE" in "Data Monitor" mode of "DAST 1".
   3. Ignition switch OFF and wait until the data monitor indication becomes between -40°F (-40°C) and 302°F (150°C).

Does the temperature become between -40°F (-40°C) and 302°F (150°C)?

YES>>

GO TO 2.

NO>>

Replace steering angle main control module. Refer to Removal and Installation .

1. CONSULT
   1. Ignition switch ON.
   2. Erase "Self Diagnostic Result" mode of "DAST 1".
   3. Ignition switch OFF and wait for at least 10 seconds.
   4. Start the engine.
      CAUTION:

      Never drive the vehicle.

   5. Select "Self Diagnostic Result" mode of "DAST 1".

Is DTC "C13DE-00" detected?

YES>>

Replace steering angle main control module. Refer to Removal and Installation .

NO>>

• Check enlarged contact spring of terminal. Refer to How to Check Terminal .
• Perform intermittent incident while turning steering wheel. Refer to Intermittent Incident .