Work Procedure

WRITING VEHICLE SPECIFICATION
1. Perform writing vehicle specification.
When writing saved data>>

GO TO 2.

When writing manually>>

GO TO 3.
PERFORM WRITING SAVED DATA
1. CONSULT
  1. Ignition switch ON.
  2. Select the "HVAC" of "Re/programming, Configuration".
  3. Select the "After Replace ECU" of "Read / Write Configuration", and write the vehicle specification into the A/C auto amp.
>>

Work End.
PERFORM WRITING MANUALLY
1. CONSULT
  1. Ignition switch ON.
  2. Select the "HVAC" of "Re/programming, Configuration".
  3. Select "Manual Configuration", and write the vehicle specification to A/C auto amp. Refer to Configuration List .
    CAUTION:
    Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
    
    Make sure to select "OK" even if the indicated configuration of brand new A/C auto amp. is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.
    NOTE: If items are not displayed, select "Next" → "OK". Refer to Configuration List for written items and setting value.
>>

Work End.