Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Turn ignition switch ON.
4. Check the voltage between ECM harness connector terminals as per the following condition.

   ECM			Condition		Voltage(Approx.)
   Connector	+	-
   	Terminal
   E16	160	161	Accelerator pedal	Fully released	0.6 - 0.9 V
   				Fully depressed	3.9 - 4.7 V
   	153	154		Fully released	0.3 - 0.6 V
   				Fully depressed	1.95 - 2.4 V

Is the inspection result normal?

>>

INSPECTION END

>>

Replace accelerator pedal assembly. Refer to Removal and Installation .