Diagnosis Procedure

1. Check for blown:

   Power source	Fuse No.	Capacity
   Ignition switch ON or START	53	10 A

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the blown fuse after repairing the affected circuit.

1. 1. Ignition switch ON.
   2. Check voltage between wireless charger unit harness connector and ground.

      (+)		(-)	Standard	Reference value
      Wireless charger unit
      Connector	Terminal
      M133	1	Ground	9.0 - 16.0 V	Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace wireless charger unit power supply harness.

1. 1. Ignition switch OFF.
   2. Disconnect wireless charger unit connector.
   3. Check continuity between wireless charger unit harness connector and ground.

      Wireless charger unit		-	Continuity
      Connector	Terminal
      M133	4	Ground	Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace wireless charger unit ground harness.