Diagnosis Procedure

1. Check that the following fuses are not blown:

   Terminal No.	Signal name	Fuse No.	Capacity
   95	Battery power supply	38	5A
   161		2	5A
   167	Battery power supply (door lock 1)	11	20A
   168	Battery power supply (turn signal)	14	10A
   169	Battery power supply (stop lamp)	49	10A
   175	Battery power supply (door lock 2)	12	15A
   176	Battery power supply (wiper)	10	15A

Is the fuse blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

1. 1. Disconnect BCM connectors.
   2. Check voltage between BCM harness connectors and ground.

      BCM		-	Voltage(Approx.)
      Connector	Terminal
      M20	161	Ground	Battery voltage
      	167
      	168
      	169
      	175
      	176
      M304	95

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

1. Check continuity between BCM harness connector and ground.

   BCM		-	Continuity
   Connector	Terminal
   M20	170	Ground	Yes
   	171

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connectors.