Diagnosis Procedure

1. Check that the following fuses are not blown:

   Unit	Power source	Fuse No.	Capacity
   Combination meter	Battery	39	10 A
   	Ignition switch ON or START	50	5 A

Is the fuse blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

1. 1. Disconnect combination meter harness connector.
   2. Check voltage between combination meter harness connector and ground.

      (+)		(-)	Ignition switch position
      Combination meter
      Connector	Terminal		OFF	ON	START
      M76	21	Ground	Battery voltage	Battery voltage	Battery voltage
      	2		0V	Battery voltage	Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connector.

1. 1. Ignition switch OFF.
   2. Check continuity between combination meter harness connector and ground.

      Combination meter		-	Continuity
      Connector	Terminal
      M76	1	Ground	Yes
      M77	41

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connector.