DTC Diagnosis Procedure

1. 1. Ignition switch OFF.
   2. Disconnect combination meter harness connector and spiral cable harness connector.
   3. Check continuity between combination meter harness connector and spiral cable harness connector.

      Combination meter		Spiral cable		Continuity
      Connector	Terminal	Connector	Terminal
      M76	3	M30	2	Yes
      	23		4
      	24		3

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		-	Continuity
      Connector	Terminal
      M76	3	Ground	No
      	23
      	24

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connector.