Component Inspection

1. 1. Ignition switch OFF.
   2. Disconnect master light switch (illumination control switch) connector.
   3. Check master light switch (illumination control switch).

      Master light switch (illumination control switch)		Condition	Continuity
      Terminals
      12	11	When master light switch (illumination control switch) (-) is pressed	Yes
      		Other than the above	No
      10		When master light switch (illumination control switch) (+) is pressed	Yes
      		Other than the above	No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace master light switch (illumination control switch). Refer to Removal and Installation .