DTC Diagnosis Procedure

1. 1. Ignition switch ON.
   2. Check voltage between the following terminals of the trip reset switch harness connector.

      Trip reset switch			Condition	Voltage(Approx.)
      Connector	Terminals
      	(+)	(-)
      M3	2	3	When trip reset switch is pressed	0 V
      			Other than the above	5 V

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 2.

1. 1. Ignition switch OFF.
   2. Disconnect combination meter harness connector and trip reset switch harness connector.
   3. Check continuity between combination meter harness connector and trip reset switch harness connector.

      Combination meter		Trip reset switch		Continuity
      Connector	Terminal	Connector	Terminal
      M77	43	M3	3	Yes
      	44		2

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		-	Continuity
      Connector	Terminal
      M77	43	Ground	No
      	44

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connector.