Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect the chassis control module harness connector.
3. Check the voltage between chassis control module harness connector and ground.

   +		-	Voltage
   Chassis control module
   Connector	Terminal
   M96	10	Ground	Approx. 0 V

4. Turn the ignition switch ON.
5. Check the voltage between chassis control module harness connector and ground.

   +		-	Voltage
   Chassis control module
   Connector	Terminal
   M96	10	Ground	6.4-16 V

Is the inspection result normal?

>>

GO TO 3.

>>

GO TO 2.

1. Turn the ignition switch OFF.
2. Check the 10A fuse (#53).
3. Check continuity between chassis control module harness connector and the fuse block (J/B).

   Chassis control module		Fuse block (J/B)		Continuity
   Connector	Terminal	Connector	Terminal
   M96	10	M44	31Q	Existed

Is the inspection result normal?

>>

Perform trouble diagnosis for ignition power supply.

>>

Repair/replace harness, connector or fuse.

Check the continuity between chassis control module harness connector and the ground.

Is the inspection result normal?

>>

GO TO 4.

>>

Repair/replace harness or connector.

Check the chassis control module terminals for damage or loose connection with harness connector.

Is the inspection result normal?

>>

INSPECTION END

>>

Repair / replace harness, connector, or terminal.