Special Repair Requirement

INITIALIZATION PROCEDURE 

Moonroof 

If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal:

1. Ignition switch ON.
   NOTE: It is best if engine is running during initialization.
2. Fully close the moonroof glass by pressing the moonroof switch in the close position.
   NOTE: If required, bump the moonroof switch repeatedly until the moonroof glass is completely closed (not in tilt-up position).
3. After holding the switch for 10 seconds, the moonroof move slightly to the closed position and then move back a little.
4. The moonroof will fully open and then fully close automatically.
5. Verify moonroof operation by tilting the moonroof glass to vent, opening and closing the moonroof.
   NOTE: Repeat this procedure if the moonroof still do not operate normally. It may be necessary to repeat the procedure up to 5 times. After 5 tries, if the moonroof still do not operate normally, clear the memory by holding the moonroof switch in the open position for 15 seconds. Then, close the moonroof and repeat the initialization procedure.

ANTI-PINCH FUNCTION 

Moonroof 

1. Fully open the moonroof to the full open position.
2. Place a piece of wood at the fully closed position.
3. Close the moonroof completely with auto-slide close function.
4. Moonroof should make contact and then tilt up or travel in reverse.