DTC Description
DTC DETECTION LOGIC
NOTE:
- If DTC B26FE is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Description .
- If DTC B26FE is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Description .
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B26FE-00 | HOOD SW CAN DIAG ERROR | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | IPDM E/R terminals 52, 103 | ||
| Threshold | BCM detects that the hood switch input is malfunctioning | ||
| Diagnosis delay time | 3 seconds | ||
POSSIBLE CAUSE
- Hood switch
- Harness or connector[hood switch circuit is open or shorted]
FAIL-SAFE
-