Work Procedure

VEHICLE CONDITION CHECK
1. 1. Park the vehicle in the straight-forward position.
  2. Unload the vehicle (no passenger aboard).
>>

GO TO 2.
SENSOR INITIALIZE
1. CONSULT
  1. Ignition switch ON.
  2. Select "LEVELIZER ADJUSTMENT" in "Work support" mode of "ADAPTIVE LIGHT".
  3. Touch "Start".
  4. When "INITIALISE COMPLETE", touch "End".
    NOTE: If "INITIALISE NOT DONE" is indicated, AFS control unit detects that the height sensor signal changes. The sensor initialize is cancelled. In this case, place the ignition switch to OFF to prevent the vehicle from the height change. Perform the sensor initialize again.
Is the sensor initialize completed?

YES>>

GO TO 3.

NO>>

Perform the sensor initialize again.
SELF DIAGNOSTIC RESULT CHECK
1. CONSULT
  1. Select "Self Diagnostic Result" mode of "ADAPTIVE LIGHT".
  2. Check DTC.
Is DTC detected?

YES>>

GO TO 2.

NO>>

Work End.