Precautions for Lane Departure Warning/Lane Departure Prevention

FRONT CAMERA UNIT HANDLING 

To keep the proper operation of the LDW/LDP systems and prevent a system malfunction, be sure to observe the following:

• Always keep the windshield clean.
• Do not attach a sticker (including transparent material) or install an accessory near the front camera unit.
• Do not place reflective materials, such as white paper or a mirror, on the instrument panel. The reflection of sunlight may adversely affect the front camera unit capability of detecting the lane markers.
• Do not strike or damage the areas around the camera unit. Do not touch the camera lens or remove the screw located on the camera unit. If the camera unit is damaged due to an accident.

LANE DEPARTURE WARNING (LDW) 

• If the LDW system malfunctions, it will cancel automatically, and the LDW malfunction message will appear in the vehicle information display.
• LDW system is only a warning device to inform the driver of a potential unintended lane departure. It will not steer the vehicle or prevent loss of control. It is the driver's responsibility to stay alert, drive safely, keep the vehicle in the traveling lane, and be in control of the vehicle at all times.
• LDW system will not operate at speeds below approximately 70 km/h (45 MPH) or if it cannot detect lane markers.
• Excessive noise will interfere with the warning chime sound, and the chime may not be heard.
• LDW system may not function properly under the following conditions:
  • On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly; yellow painted lane markers; non-standard lane markers; or lane markers covered with water, dirt or snow, etc.
  • On roads where the discontinued lane markers are still detectable.
  • On roads where there are sharp curves.
  • On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or lines remaining after road repairs. (The LDW system could detect these items as lane markers.)
  • On roads where the traveling lane merges or separates.
  • When the vehicle's traveling direction does not align with the lane marker.
  • When traveling close to the vehicle in front of driver, which obstructs the front camera unit detection range.
  • When rain, snow or dirt contacts the windshield in front of the front camera unit.
  • When the headlights are not bright due to dirt on the lens or if the aiming is not adjusted properly.
  • When strong light enters the front camera unit. (For example, the light directly shines on the front of the vehicle at sunrise or sunset.)
  • When a sudden change in brightness occurs. (For example, when the vehicle enters or exits a tunnel or under a bridge.)

LANE DEPARTURE PREVENTION (LDP) 

• If the LDP system malfunctions, it will cancel automatically, and the LDP malfunction message will appear in the vehicle information display.
• The LDP system will not always steer the vehicle to keep it in the lane. It is not designed to prevent loss of control. It is the driver's responsibility to stay alert, drive safely, keep the vehicle in the traveling lane, and be in control of vehicle at all times.
• LDP system is primarily intended for use on well-developed freeways or highways. It may not detect the lane markers in certain roads, weather or driving conditions.
• Using the LDP system under some conditions of road, lane marker or weather, or when driver change lanes without using the turn signal could lead to an unexpected system operation. In such conditions, driver needs to correct the vehicle's direction with driver's steering operation to avoid accidents.
• The LDP system will not operate at speeds below approximately 70 km/h (45 MPH) or if it cannot detect lane markers.
• Do not use the LDP system under the following conditions as it may not function properly:
  • During bad weather (rain, fog, snow, etc.).
  • When driving on slippery roads, such as on ice or snow, etc.
  • When driving on winding or uneven roads.
  • When there is a lane closure due to road repairs.
  • When driving in a makeshift or temporary lane.
  • When driving on roads where the lane width is too narrow.
  • When driving with a tire that is not within normal tire conditions (for example, tire wear, low tire pressure, installation of spare tire, tire chains, non-standard wheels).
  • When the vehicle is equipped with non-original brake or steering parts or suspension parts.
• Excessive noise will interfere with the warning chime sound, and the chime may not be heard.
• The functions of the LDP system (warning and, system application of the steering or brakes) may or may not operate properly under the following conditions:
  • On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly; yellow painted lane markers; non-standard lane markers or lane markers covered with water, dirt or snow, etc.
  • On roads where discontinued lane markers are still detectable.
  • On roads where there are sharp curves.
  • On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or lines remaining after road repairs (The LDP system could detect these items as lane markers.).
  • On roads where the traveling lane merges or separates.
  • When the vehicle's traveling direction does not align with the lane marker.
  • When traveling close to the vehicle in front of driver, which obstructs the front camera unit detection range.
  • When rain, snow or dirt contacts the windshield in front of the front camera unit.
  • When the headlights are not bright due to dirt on the lens or if the aiming is not adjusted properly.
  • When strong light enters the front camera unit (For example, the light directly shines on the front of the vehicle at sunrise or sunset.)
  • When a sudden change in brightness occurs (For example, when the vehicle enters or exits a tunnel or under a bridge.)